Chapter 19 Routing Protocol
ZyWALL Series CLI Reference Guide
183
You must first allow BGP packets to enter the Zyxel Device from the WAN using the following commands.
Router(config)# object-group service Default_Allow_WAN_To_ZyWALL
Router(group-service)# description System Default Allow From WAN To ZyWALL
Router(group-service)# service-object BGP
Router(group-service)# exit
Router(config)# show object-group
Router(config)# show object-group service
Group name Reference Family
Description
===============================================================================
CU-SEEME 0 Common
DNS 3 Common
IRC 0 Common
NetBIOS 2 Common
ROADRUNNER 0 Common
RTSP 0 Common
SNMP 0 Common
SNMP-TRAPS 0 Common
SSH 0 Common
Default_Allow_ICMPv6_Group 1 V6
Default Allow icmpv6 to ZyWALL
Default_Allow_WAN_To_ZyWALL 1 Common
System Default Allow From WAN To ZyWALL
Default_Allow_DMZ_To_ZyWALL 1 Common
System Default Allow From DMZ To ZyWALL
Default_Allow_v6_WAN_To_ZyWALL 1 Common
System Default Allow IPv6 Form WAN To ZyWALL
Default_Allow_v6_DMZ_To_ZyWALL 1 Common
System Default Allow IPv6 From DMZ to ZyWALL
DHCPv6 0 Common
Default_Allow_v6_any_to_ZyWALL 1 V6
System Default Allow IPv6 From any To ZyWALL
Router(config)#
To Next Page
Loading...
