Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
155
16.8.2 USB Storage Commands Example
This example shows how to display the status of the connected USB storage device.
16.9 VLAN Interface Specific Commands
This section covers commands that are specific to VLAN interfaces. VLAN interfaces also use many of
the general interface commands discussed at the beginning of Section 16.2 on page 121.
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
Router(config)# usb-storage activate
Router(config)# usb-storage mount
Router(config)# usb-storage update-firmware enable
Router(config)# usb-storage warn 50 percentage
Router# show usb-storage
USBStorage Configuration:
Activation: enable
Criterion Number: 50
Criterion Unit: percentage
USB Storage Status:
Device description: UFD 3.0 Silicon-Power32G
Usage: 28.9GB
Filesystem: unknown
Speed: USB 2.0 480Mbps
Status: Unused
Detail: OutOfSpace
Router# show usb-storage space ftp
Total space: 91384832
Remaining space: 42306560
Router# show usb-storage space tmp
Total space: 516079616
Remaining space: 502071296
Router# show usb-storage space usb
Total space: 5
Remaining space: 0
Router#
Table 71 Input Values for VLAN Interface Commands
LABEL DESCRIPTION
interface_nam
e
VLAN interface: vlanx, x = 0 - 4094
Ethernet interface: For some Zyxel Device models, use gex, x = 1 - N, where N equals the
highest numbered Ethernet interface for your Zyxel Device model.
For other Zyxel Devicemodels use a name such as wan1, wan2, opt, lan1, ext-wlan, or dmz.
To Next Page
Loading...
