ZyXEL Communications ZyWALL 310 - Hotspot; 32.1 Hotspot Overview; 32.2 Billing Overview; 32.3 Billing Commands

ZyWALL Series CLI Reference Guide
261
CHAPTER 32
Hotspot
32.1 Hotspot Overview
See the Introduction chapter of the ZyWALL USG Series User’s Guide for a list of models that support
Hotspot management.
32.2 Billing Overview
You can use the built-in billing function to set up billing profiles. A billing profile describes how to charge
users. This chapter also shows you how to select an accounting method or configure a discount price
plan.
32.3 Billing Commands
This table lists the billing commands. You must use the configure terminal command to enter
the configuration mode before you can use these commands.
Table 134 billing Commands
COMMAND DESCRIPTION
billing accounting-method
{accumulation | time-to-finish }
Sets how the Zyxel Device accounts the time.
accumulation: to allow each user a one-time login. Once the user logs in, the
system starts counting down the pre-defined usage even if the user stops the
Internet access before the time period is finished. If a user disconnects and
reconnects before the allocated time expires, the user does not have to enter
the user name and password to access the Internet again
time-to-finish: to allow each user multiple re-login until the time allocated is
used up. The Zyxel Device accounts the time that the user is logged in for
Internet access
billing accumulation idle-
detection timeout <1..60>
Specifies the idle timeout between 1 and 60 minutes. The Zyxel Device
automatically disconnects a computer from the network after a period of
inactivity. The user may need to enter the username and password again
before access to the network is allowed.
billing accumulation-expire {day
<1..360> | hour <1..24>}
Specifies a time unit and number to set how long to wait before the Zyxel
Device deletes an idle account.
billing currency {eur | gbp | usd
| user-define currency_code }
Sets the appropriate currency unit.
currency_code: enter a three-letter alphabetic code, such as TWD or JPY.
billing decimal-places <2>
Sets the number of decimal places to be used for billing.
billing decimal-symbol {comma |
dot}
Sets the Zyxel Device to use a dot (.) or a comma (,) for the decimal point.