EasyManua.ls Logo

ZyXEL Communications ZyWALL 310 - 11.2.2 Wireless Health Radio and Station Actions; 11.2.3 Wireless Health Command Examples

ZyXEL Communications ZyWALL 310
665 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 11 Wireless Health
ZyWALL Series CLI Reference Guide
107
11.2.2 Wireless Health Radio and Station Actions
The following table describes the action commands available for the wireless health radio and station.
You must be in the configuration mode to configure a specified radio profile before you can use the
commands. Commands that do not have IPv6 specified in the description are for IPv4.
11.2.3 Wireless Health Command Examples
For how the APs wireless network performance is improved, see Section 11.1 on page 104 for more
information.
You can set the wireless health action aggressiveness to different levels to decide when the Zyxel
Device scans for a better WiFi channel or channel bandwidth to improve the APs wireless network
performance.
A low aggressiveness level will temporarily disconnect and scan for a better WiFi channel or channel
bandwidth only when there is low level traffic in the network.
A high aggressiveness level will temporarily disconnect and scan for a better WiFi channel or channel
bandwidth when there is medium or low level traffic in the network.
Table 38 Command Summary: Wireless Health
COMMAND DESCRIPTION
wireless-health radio action
{dcs_now | downgrade_cw | none}
dcs_now: Sets the action to dcs_now to have the AP scan and
choose a radio channel that has the least interference.
downgrade_cw: Sets the action to downgrade_cw to have the
AP change the channel bandwidth from 80 MHz to 20 MHz to
reduce the radio interference with other APs.
none: Sets the action to none to have no action taken when the
AP is in a poor state of health.
wireless-health sta action
{kick_sta | none}
kick_sta: Sets the action to kick_sta to have the Zyxel
Device try to steer the wireless clients connected to an AP with a
poor signal to an AP with a strong signal every 30 minutes.
none: Sets the action to none to have no action taken when the
client is in a poor state of wireless health.
Table 39 Wireless Health Action Aggressiveness Comparison
AGGRESSIVENESS LEVEL TRAFFIC LEVEL CHANGE CHANNEL BANDWIDTH/DCS
Low Little traffic Yes
Medium traffic No
Heavy traffic No
High Little traffic Yes
Medium traffic Yes
Heavy traffic No

Table of Contents

Other manuals for ZyXEL Communications ZyWALL 310

Related product manuals