Chapter 64 System Remote Management
ZyWALL Series CLI Reference Guide
533
64.4.4 SSH Command Examples
This command sets a service control rule that allowed the computers with the IP addresses matching the
specified address object to access the specified zone using SSH service.
This command sets a certificate (Default) to be used to identify the Zyxel Device.
64.5 Telnet
You can configure your Zyxel Device for remote Telnet access.
64.6 Telnet Commands
The following table describes the commands available for Telnet. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
[no] ip ssh server v1
Enables remote management using SSH v1. The no command
stops the Zyxel Device from using SSH v1.
This command has been removed from firmware version 4.60
and later, because SSH v1 is no longer supported.
no ip ssh server rule
rule_number
Deletes a service control rule for SSH service.
show ip ssh server status
Displays SSH settings.
Table 307 Command Summary: SSH (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# ip ssh server rule 2 access-group Marketing zone WAN action
accept
Router# configure terminal
Router(config)# ip ssh server cert Default
Table 308 Command Summary: Telnet
COMMAND DESCRIPTION
[no] ip telnet server
Allows Telnet access to the Zyxel Device CLI. The no command disables Telnet
access to the Zyxel Device CLI.
[no] ip telnet server
port <1..65535>
Sets the Telnet service port number. The no command resets the Telnet service
port number back to the factory default (23).
To Next Page
Loading...
