Chapter 1 Command Line Interface
ZyWALL Series CLI Reference Guide
33
For example, look at the following command to create a TCP/UDP service object.
service-object object-name {tcp | udp} {eq <1..65535> | range <1..65535> <1..65535>}
1 Enter
service-object exactly as it appears.
2 Enter the name of the object where you see object-name.
3 Enter
tcp or udp, depending on the service object you want to create.
4 Finally, do one of the following.
•Enter
eq exactly as it appears, followed by a number between 1 and 65535.
•Enter range exactly as it appears, followed by two numbers between 1 and 65535.
1.4.6 Naming Conventions
The ATP and USG devices may have different names for the same service, but the commands for both
devices are the same. The command names will be used to refer to these services throughout this
reference guide. A list of naming differences are in the next table.
1.4.7 Changing the Password
It is highly recommended that you change the password for accessing the Zyxel Device. See Section
50.2 on page 446 for the appropriate commands.
1.4.8 Idle Timeout
See Section 50.2.1 on page 446 for commands on changing the default logout time when no activity is
recorded.
1.5 CLI Modes
You run CLI commands in one of several modes.
After you log into the Zyxel Device, you will see this prompt Router> in User mode.
Type enable and you will see this prompt Router# in Privilege mode.
Type configure terminal and you will see this prompt Router(config)# in Configuration mode.
Table 2 Naming differences between USG and ATP devices
COMMAND NAME USG SERIES NAME USG FLEX SERIES NAME ATP SERIES NAME
anti-virus Anti-Virus Anti-Malware Anti-Malware
anti-spam Anti-Spam Email Security Email Security
threat-website N/A URL Threat Filter URL Threat Filter
To Next Page
Loading...
