ZyXEL Communications ZyWALL 310 - 1.6.2 List of Sub-commands or Required User Input; 1.6.3 Entering Partial Commands

Chapter 1 Command Line Interface
ZyWALL Series CLI Reference Guide
35
Figure 9 Help: Available Commands Example 1
Figure 10 Help: Available Command Example 2
1.6.2 List of Sub-commands or Required User Input
To view detailed help information for a command, enter <command> <sub command> ?.
Figure 11 Help: Sub-command Information Example
Figure 12 Help: Required User Input Example
1.6.3 Entering Partial Commands
The CLI does not accept partial or incomplete commands. You may enter a unique part of a command
and press
[TAB] to have the Zyxel Device automatically display the full command.
Router> ?
<cr>
apply
atse
clear
configure
------------------[Snip]--------------------
shutdown
telnet
test
traceroute
write
Router>
Router> show ?
<wlan ap interface>
aaa
access-page
account
ad-server
address-object
------------------[Snip]--------------------
wlan
workspace
zone
Router> show
Router(config)# ip telnet server ?
;
<cr>
port
rule
|
Router(config)# ip telnet server
Router(config)# ip telnet server port ?
<1..65535>
Router(config)# ip telnet server port