ZyWALL Series CLI Reference Guide
295
CHAPTER 34
SSL VPN
This chapter shows you how to set up secure SSL VPN access for remote user login.
34.1 SSL Access Policy
An SSL access policy allows the Zyxel Device to perform the following tasks:
• limit user access to specific applications or files on the network.
• allow user access to specific networks.
• assign private IP addresses and provide DNS/WINS server information to remote users to access
internal networks.
34.1.1 SSL Application Objects
SSL application objects specify an application type and server that users are allowed to access through
an SSL tunnel. See Chapter 60 on page 503 for how to configure SSL application objects.
34.1.2 SSL Access Policy Limitations
You cannot delete an object that is used by an SSL access policy. To delete the object, you must first
unassociate the object from the SSL access policy.
34.2 SSL VPN Commands
The following table describes the values required for some SSL VPN commands. Other values are
discussed with the corresponding commands.
Table 157 Input Values for SSL VPN Commands
LABEL DESCRIPTION
profile_name
The descriptive name of an SSL VPN access policy. You may use up to 31 characters (“a-
z”, A-Z”, “0-9”) with no spaces allowed.
address_object
The name of an IP address (group) object. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
application_obje
ct
The name of an SSL application object. You may use up to 31 characters (“0-9”, “a-z”, “A-
Z”, “-” and “_”). No spaces are allowed.
user_name
The name of a user (group). You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
To Next Page
Loading...
