Chapter 65 File Manager
ZyWALL Series CLI Reference Guide
557
7 Enter atgo. The Zyxel Device starts up. If “Connect a computer to port 1 and FTP to 192.168.1.1 to upload
the new file” displays on the screen, the firmware file is damaged and you need to use the procedure in
Section 65.12 on page 557 to recover the firmware.
Figure 53 atgo Debug Command
65.12 Restoring the Firmware
This procedure requires the Zyxel Device’s firmware. Download the firmware package from
www.zyxel.com and unzip it. The firmware file uses a .bin extension, for example, "1.01(XL.0)C0.bin". Do
the following after you have obtained the firmware file.
Note: This section is not for normal firmware uploads. You only need to use this section if you
need to recover the firmware.
1 Connect your computer to the Zyxel Device’s port 1 (only port 1 can be used).
2 The Zyxel Device’s FTP server IP address for firmware recovery is 192.168.1.1, so set your computer to use
a static IP address from 192.168.1.2 ~192.168.1.254.
3 Use an FTP client on your computer to connect to the Zyxel Device. For example, in the Windows
command prompt, type ftp 192.168.1.1. Keep the console session connected in order to see when
the firmware recovery finishes.
4 Hit enter to log in anonymously.
5 Set the transfer mode to binary (type bin).
6 Transfer the firmware file from your computer to the Zyxel Device. Type put followed by the path and
name of the firmware file. This examples uses put e:\ftproot\ZLD FW \1.01(XL.0)C0.bin.
Figure 54 FTP Firmware Transfer Command
7 Wait for the file transfer to complete.
To Next Page
Loading...
