Chapter 65 File Manager
ZyWALL Series CLI Reference Guide
556
Note: You only need to use the atuk or atur command if the recovery image is damaged.
Figure 49 atuk Command for Restoring the Recovery Image
4 Enter Y and wait for the “Starting XMODEM upload” message before activating XMODEM upload on
your terminal.
Figure 50 Starting Xmodem Upload
5 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer, then Send File to
display the following screen.
Figure 51 Example Xmodem Upload
6 Wait for about three and a half minutes for the Xmodem upload to finish.
Figure 52 Recovery Image Upload Complete
Type the firmware file's location,
or click Browse to search for it.
Choose the 1K Xmodem
protocol.
Then click Send.
To Next Page
Loading...
