ZyXEL Communications ZyWALL 310 - 12.2.1 Wireless Frame Capture Examples; 12.2.2 Remote Packet Capture

Chapter 12 Wireless Frame Capture
ZyWALL Series CLI Reference Guide
110
The following table describes the commands available for wireless frame capture. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
12.2.1 Wireless Frame Capture Examples
This example configures the wireless frame capture parameters for an AP located at IP address
192.168.1.2.
This example shows frame capture status and configuration.
12.2.2 Remote Packet Capture
Remote packet capture allows you to capture network traffic going through an AP, and output the
captured packets to a packet analyzer (also known as network or protocol analyzer) such as Wireshark.
Table 41 Command Summary: Wireless Frame Capture
COMMAND DESCRIPTION
frame-capture configure
Enters sub-command mode for wireless frame
capture.
src-ip {add|del} {ipv4_address |
local}
Sets or removes the IPv4 address of an AP controlled
by the Zyxel Device that you want to capture wireless
network traffic going through the AP interfaces. You
can use this command multiple times to add
additional IPs to the list.
file-prefix file_name
Sets the file name prefix for each captured file. Enter
up to 31 alphanumeric characters. Spaces and
underscores are not allowed.
files-size mon_dir_size
Sets the total combined size (in kbytes) of all files to be
captured.
exit
Exits configuration mode for wireless frame capture.
[no] frame-capture activate
Starts wireless frame capture. Use the no parameter to
turn it off.
show frame-capture status
Displays whether frame capture is running or not.
show frame-capture config
Displays the frame capture configuration.
Router(config)# frame-capture configure
Router(frame-capture)# src-ip add 192.168.1.2
Router(frame-capture)# file-prefix monitor
Router(frame-capture)# files-size 1000
Router(frame-capture)# exit
Router(config)#
Router(config)# show frame-capture status
capture status: off
Router(config)# show frame-capture config
capture source: 192.168.1.2
file prefix: monitor
file size: 1000