Chapter 12 Wireless Frame Capture
ZyWALL Series CLI Reference Guide
111
You must use the configure terminal command to enter the configuration mode before you can
use these commands.
Note: To start, stop, and configure remote packet capture on an AP, log into the Web
Configurator and then go to Maintenance > Diagnostics > Packet Capture > Remote
Capture.
Table 42 Command Summary: Remote Capture
COMMAND DESCRIPTION
show capwap ap all lite2
Lists all connected APs, and shows whether they support
packet capture and remote packet capture.
show remote-capture status Shows whether remote capture is currently running on the
Zyxel Device.
To Next Page
Loading...
