ZyXEL Communications ZyWALL 310 - 3.1.1 Object Reference Command Example

Chapter 3 Object Reference
ZyWALL Series CLI Reference Guide
46
3.1.1 Object Reference Command Example
This example shows how to check which configuration is using an address object named LAN1_SUBNET.
For the command output, firewall rule 3 named LAN1-to-USG-2000 is using the address object.
show reference object isakmp policy
[isakmp_name]
Displays which configuration settings reference the specified VPN gateway
object.
show reference object sslvpn policy
[object_name]
Displays which configuration settings reference the specified SSL VPN object.
show reference object zone
[object_name]
Displays which configuration settings reference the specified zone object.
show reference object dhcp6-lease-
object [object_name]
Displays which configuration settings reference the specified DHCPv6 lease
object.
show reference object dhcp6-
request-object [object_name]
Displays which configuration settings reference the specified DHCPv6 request
object.
show reference object-group
username [username]
Displays which configuration settings reference the specified user group
object.
show reference object-group address
[object_name]
Displays which configuration settings reference the specified address group
object.
show reference object-group
address6 [object_name]
Displays which configuration settings reference the specified IPv6 address
group object.
show reference object-group service
[object_name]
Displays which configuration settings reference the specified service group
object.
show reference object-group
interface [object_name]
Displays which configuration settings reference the specified trunk object.
show reference object-group aaa ad
[group_name]
Displays which configuration settings reference the specified AAA AD group
object.
show reference object-group aaa
ldap [group_name]
Displays which configuration settings reference the specified AAA LDAP
group object.
show reference object-group aaa
radius [group_name]
Displays which configuration settings reference the specified AAA RADIUS
group object.
Table 6 show reference Commands (continued)
COMMAND DESCRIPTION
Router(config)# show reference object address LAN1_SUBNET
LAN1_SUBNET References:
Category
Rule Priority Rule Name
Description
===========================================================================
Security Policy Control
3 N/A
LAN1-to-USG-2000
Router(config)#