Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
148
Device error a 3G device is connected but there is an error.
Probe device fail the Zyxel Device’s test of the 3G device failed.
Probe device ok the Zyxel Device’s test of the 3G device failed.
Init device fail the Zyxel Device was not able to initialize the 3G device.
Init device ok the Zyxel Device initialized the 3G card.
Check lock fail the Zyxel Device’s check of whether or not the 3G device is locked failed.
Device locked the 3G device is locked.
SIM error there is a SIM card error on the 3G device.
SIM locked-PUK the PUK is locked on the 3G device’s SIM card.
SIM locked-PIN the PIN is locked on the 3G device’s SIM card.
Unlock PUK fail Your attempt to unlock a WCDMA 3G device’s PUK failed because you entered an
incorrect PUK.
Unlock PIN fail Your attempt to unlock a WCDMA 3G device’s PIN failed because you entered an
incorrect PIN.
Unlock device fail Your attempt to unlock a CDMA2000 3G device failed because you entered an incorrect
device code.
Device unlocked You entered the correct device code and unlocked a CDMA2000 3G device.
Get dev-info fail The Zyxel Device cannot get cellular device information.
Get dev-info ok The Zyxel Device succeeded in retrieving 3G device information.
Searching network The 3G device is searching for a network.
Get signal fail The 3G device cannot get a signal from a network.
Network found The 3G device found a network.
Apply config The Zyxel Device is applying your configuration to the 3G device.
Device unready The 3G interface is disabled.
Active The 3G interface is enabled.
Incorrect device The connected 3G device is not compatible with the Zyxel Device.
Correct device The Zyxel Device detected a compatible 3G device.
Set band fail Applying your band selection was not successful.
Set band ok The Zyxel Device successfully applied your band selection.
Set profile fail Applying your ISP settings was not successful.
Set profile ok The Zyxel Device successfully applied your ISP settings.
PPP fail The Zyxel Device failed to create a PPP connection for the cellular interface.
Need auth-password You need to enter the password for the 3G card in the cellular edit screen.
Device ready The Zyxel Device successfully applied all of your configuration and you can use the 3G
connection.
Table 67 Cellular Status
STATUS DESCRIPTION
To Next Page
Loading...
