ZyXEL Communications ZyWALL 310 - Page 253

Chapter 31 Web Authentication
ZyWALL Series CLI Reference Guide
253
show web-auth redirect-
fqdn
Displays the FQDN of the Zyxel Device interface to which the clients connect
to authenticate through the internal web portal page
web-auth redirect-
parameter
Enters redirect parameter subcommand mode, and change the names of
the following parameters.
• ap_ip
• ap_mac
• client_ip
• client_mac
• ssid_name
• vlan_id
To use an external web portal for web authentication, you need to use the
parameters’ names that are adopted by the external web portal. Thus, you
can be directed successfully to the external web portal.
The Zyxel Device will automatically add these parameters to the URL of the
external web portal when you’re directed to the web portal for web
authentication.
{ap_ip|ap_mac|client_
ip|client_mac|ssid_na
me|vlan_id }
new_parameter
Changes the name of the following parameters. You can only change a
parameter’s name at a time.
{ap_ip|ap_mac|client_ip|client_mac|ssid_name| vlan_id }: Enters
the parameter of which you want to change the name.
new_parameter: Enters a new name for the parameter.
mac_delimiter
{colon|hyphen}
Specifies the separator the external server uses for the two-character pairs
within MAC addresses used.
For example, use mac delimiter hyphen if you need to use a MAC
address formatted like 00-11-AC-01-A0-11.
no web-auth redirect-
parameter
Resets the names of the parameters to the default settings.
show web-auth redirect-
parameter
Displays the names of the following parameters:
• ap_ip
• ap_mac
• client_ip
• client_mac
• ssid_name
• vlan_id
web-auth web-portal
Enters web portal subcommand mode.
session-page
{activate |
deactivate}
Redirects to a ‘Welcome page’ after login when activated.
show web-auth activation
Displays whether forcing user authentication is enabled or not.
show web-auth default-
rule
Displays settings of the default web authentication policy.
show web-auth
exceptional-service
Displays services that users can access without user authentication.
show web-auth method
Displays whether a client is to authenticate with the Zyxel Device through the
specifically designated web portal when web authentication is enabled.
show web-auth policy
{<1..1024> | all}
Displays details about the policies for forcing user authentication.
Table 128 web-auth Commands (continued)
COMMAND DESCRIPTION