Chapter 11 Wireless Health
ZyWALL Series CLI Reference Guide
105
The following table describes the commands available for the wireless health. You must use the
configure terminal commands to enter the configuration mode before you can use the
configuration commands. Commands that do not have IPv6 specified in the description are for IPv4.
Table 36 Command Summary: Wireless Health
COMMAND DESCRIPTION
wireless-health-action
aggressiveness {high | standard |
low}
Sets a level to decide when the Zyxel Device takes actions to
improve the APs wireless network performance. Actions the Zyxel
Device can take are changing the channel bandwidth from
80MHz to 20MHz, DCS, or directing clients to APs with a stronger
WiFi signal.
High, standard and low stand for different traffic rate threshold
levels. The Zyxel Device will postpone the actions implemented on
APs until your network is less busy if the threshold is exceeded.
High: Sets the level to high if you want the Zyxel Device to
postpone the action set when the AP network traffic is more than
heavy.
Standard: Sets the level to standard if you want the Zyxel Device
to postpone the action set when the AP network traffic is more
than medium.
Low: Sets the level to low if you want the Zyxel Device to postpone
the action set when the AP network traffic is more than low.
[no] wlan-radio-profile radio
profile name
Enters configuration mode for the specified radio profile. Use the
no command to remove the specified profile.
[no] wireless-health
{activate | radio | sta}
activate: Enables Wireless Health. Use the no command to
disable this feature.
radio: Configure wireless health settings for the APs in Zyxel
Device networks. See Section 11.2.1 on page 106 for more
information on radio settings commands.
sta: Configure wireless health settings for the wireless clients
which are connected to the supported APs in Zyxel Device
networks. See Section 11.2.1 on page 106 for more information on
station settings commands.
To Next Page
Loading...
