User and Error Messages
360
D
ERROR... The noise frequency is out of range!
Condition: The noise offset frequency plus the carrier frequency exceeds
the range of the unit.
Response: Choose a smaller noise offset frequency value.
ERROR... Insufficient signal level to perform the measurement!
Condition: A minimum carrier level is required for C/N and HUM
measurements.
Response: Choose another channel or frequency with greater than the
minimum level.
SORRY... This is an illegal name and cannot be used.
Condition: An illegal name has been entered.
Response: Choose another name.
WARNING...A reference with this name already exists. Overwrite?
Condition: A reference with the same name currently exists.
Response: Overwrite the existing reference or choose another name.
SORRY... This is an invalid name. Please try again.
Condition: An invalid name has been entered.
Response: The name must contain at least one character.
SORRY... There is not enough memory to store a new reference!
Condition: Memory is currently at maximum capacity.
Response: Delete unwanted files to make more memory available.
WARNING... The selected reference will be deleted!
Condition: A reference file is about to be deleted.
Response: Press OK to delete.
ERROR... The selected reference has been corrupted!
Condition: The reference cannot be used because of a non-volatile
memory failure.
Response: Delete the corrupted reference and select another.
To Next Page
Loading...
