User and Error Messages
361
D
SORRY... Not enough sweeps have occurred to store an accurate reference. Please
allow more time in SWEEP.
Condition: An attempt to store a reference without sufficient sweeps.
Response: Allow more time in Sweep Mode.
ERROR... A system error has occurred!
Condition: A system error has been detected.
Response: Restart the unit and try again.
ERROR... There is no Response: from the printer!
Condition: The printer is not responding to the unit.
Response: Check printer connection and compatibility.
SORRY... There is nothing to print! Please select a measurement mode before
attempting to print.
Condition: An attempt to print was made without being in a measurement
mode.
Response: Choose a measurement mode.
WARNING... A sweep file with this name already exists. Overwrite?
Condition: A sweep file with the same name currently exists.
Response: Overwrite or choose another name.
SORRY... There is not enough memory to store a new file!
Condition: Memory is currently at maximum capacity.
Response: Delete unwanted files to make more memory available.
WARNING... The selected sweep file will be deleted!
Condition: A sweep file is about to be deleted.
Response: Press OK to delete.
ERROR... The selected sweep file has been corrupted!
Condition: The file cannot be used because of a non-volatile memory
failure.
Response: Delete the corrupted file and select another sweep file.
To Next Page
Loading...
