User and Error Messages
362
D
ERROR... A system error has occurred! Please select another mode.
Condition: A system error has been detected.
Response: Select another measurement mode or restart the unit and try
again.
ERROR... At least two tilt channels must be programmed and enabled! Please
select another mode.
Condition: Tilt mode is selected with less than two tilt channels
programmed.
Response: Edit channel plan to program at least two tilt channels.
WARNING... The selected plan will be deleted.
Condition: A channel plan is about to be deleted.
Response: Press OK to delete, STOP to cancel.
SORRY... The active plan cannot be deleted!
Condition: An attempt to delete the active channel plan.
Response: Select a different plan as the active plan, then delete the
desired plan.
ERROR... This plan is corrupted and cannot be used!
Condition: The plan cannot be used because of a non-volatile memory
failure.
Response: Delete the plan and then choose another.
WARNING... A plan with this name already exists. Overwrite?
Condition: A channel plan with the same name currently exists.
Response: Overwrite or choose another name.
SORRY...This is the name of a fixed plan and cannot be used.
Condition: An attempt was made to name a channel plan with the name
of a fixed plan.
Response: Choose another name.
ERROR... The stop frequency has been set too low.
Condition: The stop frequency has been set below the lowest channel in
the selected fixed plan.
Response: Enter a higher stop frequency.
To Next Page
Loading...
