User and Error Messages
363
D
SORRY... This cannot be completed due to a system error.
Condition: A system error was detected.
Response: Restart the unit and try again.
WARNING... This channel will be deleted!
Condition: A channel is about to be deleted.
Response: Press OK to delete, STOP to cancel.
SORRY... The last channel cannot be deleted!
Condition: An attempt was made to delete the last channel of a plan.
Response: A channel plan must contain at least one channel. If desired,
delete the entire plan.
WARNING... This operation cannot be undone!
Condition: An operation has been selected that will make permanent
changes to a stored file.
Response: Press OK to execute, STOP to cancel.
SORRY... There is not enough memory to store the new plan!
Condition: Memory is currently at maximum capacity.
Response: Delete unwanted files to make more memory available.
WARNING... There is not enough memory to save the changes!
Condition: Memory is currently at maximum capacity.
Response: Delete unwanted files to make more memory available.
SORRY... Some channels may not have been converted due to a system error.
Condition: A system error was detected.
Response: Restart the unit and try again.
WARNING... All files and stored settings will be lost!
Condition: The unit is being reset to the factory default settings.
Response: Press OK to reset settings, STOP to cancel.
ERROR... C/N cannot be measured on a scrambled channel!
Condition: A channel that has been programmed as scrambled in setup
has been selected in C/N mode.
Response: Select a channel that is not scrambled. C/N measurements
are not possible on a scrambled channel.
To Next Page
Loading...
