User and Error Messages
364
D
ERROR... Hum cannot be measured on a scrambled channel!
Condition: A channel that has been programmed as scrambled in setup
has been selected in Hum mode.
Response: Select a channel that is not scrambled. Hum measurements
are not possible on a scrambled channel.
SORRY... No more tilt channels can be programmed.
Condition: The maximum number of tilt channels has been reached.
Response: To program another tilt channel, an existing tilt channel must
be reprogrammed as a non-tilt channel.
ERROR... QAM board did not power up!
Condition: The QAM digital board is not receiving power to operate.
Response: Restart the unit and try again.
ERROR... Incorrect QAM version.
Condition: The firmware version of this unit is incompatible with QAM
OPT4 software.
Response: Upgrade the firmware.
ERROR... Signal Unlocked. Confirm Connection to Dig Port. Retry.
Condition: The unit is unable to lock onto a digital signal.
Response: Confirm connection to digital port and accuracy of channel
plan setup. (Also confirm sufficient signal strength using the analog port
and level mode.)
To Next Page
Loading...
