To Next Page

To Previous Page

Appendix C, Ethernet OAM Provisioning - Ethernet OAM on the NetVanta 800/8000 Series NCTE

65K510DEP08-1A C-7

Single‐tagCFMservicefors‐tag100:

• Component1VLAN100DownMEPontheMEN‐port

• Component1VLAN100UpMEPontheUNIdefinedbyanEVC‐mapconnectedto

theEVCwiths‐tag100

Single‐tagCFMserviceforc‐tag20towards customer:

• Component2VLAN

20DownMEPontheUNI‐portforcustomerCFMservice

operability.

Double‐tagCFMservicefors‐tag100,c‐tag20destinedfor aProvidernetwork:

• Component2VLAN20UpMEPontheUNI‐portdefinedbyanEVC‐mapconnected

totheEVCwiths‐tag100

9. Type

exit,andpressENTER toreturntotheMDprompt.

10. Type

exit,andpressENTER toreturntotheGlobalConfigurationprompt.

11. AMIPcanbecreatedonaspecificVIDandspecific MDlevelbyenteringtheDefault

MD.TheMIPwillbecreatedonallMEN‐portswiththatVIDsolongthataDownMEP

onthesameVIDdoesn’texistata

equalorhigherlevel.

12. FromtheGlobalConfigurationprompt,entertheEthernetCFMDefaultMDbytyping

ethernet cfm default-domain,andpressENTER.

13. FromtheDefault‐MDComponentprompt,type

component 1 vlan <2-4094>,and

press

ENTERtoconfiguretheMIPcreationsettingsforthespecifiedProviderVLAN.

AprerequisiteforeditingaDefault‐MDComponentisthattheVLANmustalreadybe

definedbyaEVCusingthesames‐tagandintheRunningstate.IfnosuchEVCexists,

thentheMIPrulescannot

beaccessedforthatDefault‐MDComponentVID.

14. FromtheDefault‐MDComponentprompt,type

level <0-7>,andpressENTER.TheMIP

creationwillbeattemptedatthespecifiedMDlevelforthisProviderVID.

15. FromtheDefault‐MDComponentprompt,type

mip-allowed any,andpress ENTERto

allowMIPstobecreatedonthisProviderVID.

16. Type

exit,andpressENTERtoreturntotheGlobalConfigurationprompt.

ADTRAN TA 5000 User Manual

Questions and Answers: