586 Rockwell Automation Publication 193-UM015E-EN-P - October 2015
Chapter 10 EtherNet/IP Communication
4. Type a name for the E300 relay, and press Change to update the module
definition.
5. Press Upload to read the configuration settings from the E300 relay.
ATTENTION: If an Upload command is not performed, any preconfigured E300
relay configuration data is not retained when downloading an RSLogix 5000 or
Studio 5000 project to a Logix controller or when adding a new E300 relay
online to a ControlLogix project.
To Next Page
Loading...
