5. Troubleshooting
Code 100055: “Init dvi adc failed, input 1” (Error)
Situation Solution
Internal projector so ftware error. First s olve error/warning messages with ID number below 100000 . If problem rem ains,
contact Barco.
Code 100056: “Init dvi adc failed, input 3” (Error)
Situation Solution
Internal projector so ftware error. First s olve error/warning messages with ID number below 100000 . If problem rem ains,
contact Barco.
Code 100057: “Init dvi firmware failed, input 2” (Error)
Situation Solution
Internal projector so ftware error. First s olve error/warning messages with ID number below 100000 . If problem rem ains,
contact Barco.
Code 100058: “Init dvi firmware failed, input 4” (Error)
Situation Solution
Internal projector so ftware error. First s olve error/warning messages with ID number below 100000 . If problem rem ains,
contact Barco.
Code 100059: “Init dvi settings failed, input 2” (Error)
Situation Solution
Internal projector so ftware error. First s olve error/warning messages with ID number below 100000 . If problem rem ains,
contact Barco.
Code 100060: “Init dvi settings failed, input 4” (Error)
Situation Solution
Internal projector so ftware error. First s olve error/warning messages with ID number below 100000 . If problem rem ains,
contact Barco.
Code 103000: “Storage: successful restoring” (Info)
Situation Solution
The pro jector settings we re
successfully stored in the backup
device.
No ac tions required.
Code 103001: “Storage: successful restoring with fall back mgt
file” (Warning)
Situation Solution
The pro jector settings we re
successfully restored from in the
backup device after running the
recovery procedure.
No ac tions required.
Code 103002: “Storage: unsuccessful restoring” (Error)
Situation Solution
The projector was not able to restore
the projector settings succ essf u lly
from the bac kup device.
The projector will still be operational. But if the Input & Communication unit has to be
replaced then the projector settings w ill be los t and needs to be m anually uploade d. No te
this can only be done at factory or by qualified B arco service technicians.
To solve this issue save t he projector Cu stom Settings and reboot the projector. If this
error persists, contact Barco for further actions.
Code 103003: “Storage: restoring without any preceding storing” (Info)
Situation Solution
No data found in m emory of backup
device.
No actions required. Projector will update data automatically.
96 R5905312 HDF W SERIES 24/01/2013
To Next Page
Loading...
Need help?
General
