14. Lenses and Lens Holder
14.8 Removing the Lens Holder
WARNING: Disconnect the power cord from the projector and wait a few minutes (to discharge the capacitors)
prior to start with this procedure.
Necessary tools
•7mmflat screwdriver.
• Side cutter.
• 3mm Allen wrench.
• 5mm Allen wrench.
How to remove the Lens Holder from the projector?
1. R emov e the lens, front cover from the projector.
2. D isconnect all wire units (reference 1 image 14-32) of the wire three from the Lens Holder.
1
Image 14-25
3. D isconnect the EMC wire unit (reference 2 image 14-26) of the Lens Holder from the frame.
2
Image 14-26
4. D isconnect the wire unit (reference 3 image 14-27) of the horizontal shift motor and the wire unit (reference 4 image 14-28) of
the vertical shift motor.
226
R5905312 HDF W SERIES 24/01/2013
To Next Page
Loading...
