10. Card Cage
10.13 Replacing the LCD Display
This procedure assumes that the Input & Communication unit is already removed from the projector.
Necessary tools
5.5mm nut d river.
How to replace the LCD Display?
1. R emov e the complete PMP board assembly from the Input & Comm unication unit. See first steps of the service procedure
"Replacing the PMP board", page 156.
2. R emov e the LCD Display Interface first. See service procedure "Replacing the LCD Display Interface", pag e 161.
3. R eplace the LCD Display. use a 5.5mm nut d river to loosen/fasten the four screws of the m ounting plate at the rear side of the
LCD Display.
Caution: Ensure that the port view and the screen of the LCD Display are clean.
1
Image 10-34
4. Install the LCD Display Interface. See service procedure "Replacing t he LCD Display Interface", page 161.
5. Install the complete PMP board assembly back o
n the Input & Communication unit. See service procedure "Replacing the P MP
board", page 15 6.
R5905312 HDF W SERIES 24/01/2013
163
To Next Page
Loading...
