Barco HDF W series - 13 HDF Light Processor

13. HDF Light Processor
13. HDF LIGHT PROCESSOR
About this chapter
This chapter gives a brief introduction o f the Light processor assembly. Futhermore this chapter includes the replacement procedure
of the whole Light Processor.
WARNING: The procedures below may only be performed by trained and qualified technicians.
CAUTION: All servicing to the Light Processor has to be done in a dust free area. Use compressed air to blow
away all dust on the outside of the Light Processor before entering the projector into the dust free area.
CAUTION: Wear a wrist band which is connected to the ground while handling the electrostatic disch
arge
sensitive parts.
CAUTION: Remove the projector lens before removing the Light Processor.
Overview
• Introduction HDF Light Processor
• Diagnostic
• Removing the Light P rocessor
• Installing the Light Proce ssor
• Replacement of the s hutter
• Cleaning the Prism ex it side
• Light Sensor module replacement
• Adjusting the Fold M irror
• High Contrast plate replacement
• Convergence controls
• Converging the red pattern onto the blue pattern
• Converging the green pattern onto the blue pattern
R5905312 HDF W SERIES 24/01/2013
189