Barco HDF W series - Removal of the Input Cover

6. Removal and installation of the projector covers
6.4 Removal of the input cover
WARNING: This procedure may only be performed by qualified technical service personnel.
Necessary tools
7mmflat screw drive r.
How to remove the input cover
1. R elease the two captive screws at the top an d bottom left s ide of the input cover, using a flat screw driver.
Image 6-7
Captive screws input cover
2. R emov e the input cover from the projector as follows:
a) gently pull out the right bottom c orner (A) of the input cover,
b) then gently pull out the right top corner (B) of the input cover,
c) then move the input cover away from the projector (C).
B
A
C
Image 6-8
Input cover removal
R5905312 HDF W SERIES 24/01/2013 101