14. Lenses and Lens Holder
10
11
Image 14-48
4. R einstall the stepper motor on the ass embly as illustrated in image 14-47. Fasten the four screws (reference 9) witha3mm
Allen wrench.
5. R einstall the front plate from the Lens Holder. Us e a 13mm open end wrench to fasten the four big n uts (reference 2 image 14-46).
Fasten the big nuts crosswise bit by bit. Ensure that the u pper two rods and the lower left rod contain a big spring.
Proceed with reinstalling the Lens Holder and calibrate the Motor Control Board. See procedure "Lenses and
Lens Holder", page 215, and "Calibrate Motor Control Board", page 286
The Lens Holder has to be adjusted after installation. See procedure "Scheimpflug adjustment", page 230.
R5905312 HDF W SERIES 24/01/2013 237
To Next Page
Loading...
