Branson 2000X - Page 153

2000X energy Power Supply Chapter 6: Operation
Instruction Manual Saving and Recalling Presets
011-003-991 EN 6-61
To allow the Power Supply to name
the preset, after pressing the Select
key that corresponds to Automati-
cally Name, you will see the name
for the preset appear in the Save
Preset list. The convention for nam-
ing presets is as follows:
Time: Tm = xxxxS
Energy: En = xxxxJ
Peak Power: PP = xxx%
Absolute: Ab = xxx IN
Collapse: Cl = xxx IN
Ground Detect: GD = xxxS
Power Supply will assign same
name to all according to mode.
To assign a name to a preset, after
pressing the Select key that corre-
sponds to Assign ID Name, you will
see a submenu where you will
assign a name to the preset. To do
this, use the arrow keys to scroll to
each letter or number you want to
select and press Enter on the
numeric keypad after each charac-
ter. Press the Select key that corre-
sponds to Done when you have
entered the name you want to use.
If you are using an optional
remote terminal, you are limited to
only these characters.
If there is a preset currently in a particular
position, you can overwrite the current pre-
set by pressing the Select key that corre-
sponds to OK, or choose not to overwrite
the current preset by pressing the Select
key that corresponds to Cancel.
SAVE Pg2of10
01 En=1.0J
02 Tm=0.010
03>
SAVE
ABCDEFGHIJKLM./01234
NOPQRSTUVWXYZ#56789
01 Done
Select
Select
Select
OVERWRITE PRESET? 1
OK>
Cancel>
Select
Select
Select