Branson 2000X - Page 31

2000X energy Power Supply Chapter 4: Installation and Setup
Instruction Manual
011-003-991 EN 4-1
Chapter 4: Installation and Setup
4.1 About Installation - - - - - - - - - - - - - - - - - - - - - - -4 - 2
4.2 Handling and Unpacking - - - - - - - - - - - - - - - - - - -4 - 2
4.2.1 Unpack the Power Supply - - - - - - - - - - - - - - - - - -4 - 3
4.2.2 Unpack the Stand or Actuator- - - - - - - - - - - - - - - - -4 - 3
4.2.3 Stand (actuator on a base) - - - - - - - - - - - - - - - - - -4 - 4
4.2.4 Stand (Actuator on a Hub) - - - - - - - - - - - - - - - - - -4 - 5
4.2.5 Actuator (alone) - - - - - - - - - - - - - - - - - - - - - - -4 - 6
4.3 Take Inventory of Small Parts- - - - - - - - - - - - - - - - -4 - 7
4.3.1 Cables - - - - - - - - - - - - - - - - - - - - - - - - - - - -4 - 8
4.4 Installation Requirements- - - - - - - - - - - - - - - - - - -4 - 9
4.4.1 Location - - - - - - - - - - - - - - - - - - - - - - - - - - -4 - 9
4.4.2 Environmental Specifications - - - - - - - - - - - - - - - - 4 - 12
4.4.3 Electrical Input Power Ratings - - - - - - - - - - - - - - - 4 - 12
4.4.4 Factory Air - - - - - - - - - - - - - - - - - - - - - - - - - 4 - 13
4.5 Installation Steps - - - - - - - - - - - - - - - - - - - - - - 4 - 14
4.5.1 Mounting the Stand (Actuator on Base) - - - - - - - - - - - 4 - 14
4.5.2 Mounting the Stand (Actuator on Hub-mounted column)- - - 4 - 15
4.5.3 Actuator (alone) - - - - - - - - - - - - - - - - - - - - - - 4 - 16
4.5.4 Mount the Power Supply - - - - - - - - - - - - - - - - - - 4 - 18
4.5.5 Interconnect between Power Supply and Actuator- - - - - - 4 - 18
4.5.6 Input Power (Main) - - - - - - - - - - - - - - - - - - - - - 4 - 19
4.5.7 Output Power (RF Cable)- - - - - - - - - - - - - - - - - - 4 - 19
4.5.8 Interconnect between Power Supply and Actuator- - - - - - 4 - 20