2-34
Confidential
Small paper
Open the Back Cover and
then press Go.
Registration front sensor detected
that the paper size for printing by
specifying DDL (DL Long Edge), is
smaller than the specified size.
5C00 2-71
Storage Error
To use other functions,
press GO. Refer to the
User's Guide for
instructions on correcting
the Storage Error.
Failed read/write data in the storage
I/O.
0D01 2-37
Storage Full
There is no space in the
Memory.
Unable to save data because there is
no space in the storage data area of
memory.
0D00 2-37
Table Print
Change Emulation
Emulation performed table print by
PS fixed.
--- 4.4.1
Too Many Trays
Maximum number of
optional trays is three.
Remove additional trays.
Detected when 4 or more optional
tray was connected.
1F00 2-38
Tray 1 Error
Pull out Tray 1 completely.
Check inside the Tray.
Within the specified time, plate
sensor of the tray 1 was unable to
detect completion of lift-up.
C401 2-105
Tray 2 Error
Pull out Tray 2 completely.
Check inside the Tray.
Within the specified time, plate
sensor of the tray 2 was unable to
detect completion of lift-up.
C402 2-105
Tray 3 Error
Pull out Tray 3 completely.
Check inside the Tray.
Within the specified time, plate
sensor of the tray 3 was unable to
detect completion of lift-up.
C403 2-105
Tray 4 Error
Pull out Tray 4 completely.
Check inside the Tray.
Within the specified time, plate
sensor of the tray 4 was unable to
detect completion of lift-up.
C404 2-105
Unusable Device
Remove the Device. Turn
the power off and back on
again.
The overcurrent protection circuit
worked when an off-specification
USB device was inserted into the
USB host terminal.
CA00 2-106
Waste Tank Alert
The Waste Tank is almost
full - Printing can continue
until full. Call for Service to
have Waste Tank replaced.
Waste ink tank almost reaches time
for replacement.
5100 2-66
Error message Problem
Error
codes
Refer to:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
