utilization-mark
To specify a utilization threshold, use the utilization-mark command in Pool IPv4 or IPv6 configuration
submode. To remove the utilization threshold, use the no form of this command.
utilization-mark {high| high_value| low| low_value}
no utilization-mark {high| high_value| low| low_value}
Syntax Description
Specifies the high mark in the threshold value.high
Specifies the numerical value as percentage, for the low mark in the threshold.
high_value
Specifies the low mark in the threshold value.low
Specifies the numerical value as percentage, for the low mark in the threshold.
low_value
Command Default
None
Command Modes
Pool IPv4 configuration
Pool IPv6 configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the pool ipv4 command to enter IPv4 pool configuration submode and pool ipv6 command to enter IPv6
pool configuration submode.
When the utilization threshold is reached, a LOG_WARNING message is logged with syslog facility. The
high and low values are entered as percentages between 0 and 100. The utilization is defined as the # allocated
addresses or # total addresses.
Task ID
OperationTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
96
Address Pool Service Commands
utilization-mark
To Next Page
Loading...
Need help?
General
