Cisco ASR 9000 Series Command Reference

Command Modes
Class-map configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
The command was modified to add new keyword, service-name.Release 5.2.2
Usage Guidelines
Use the class-map type control subscriber command to enter class-map configuration mode.
These are the usage guidelines for match service-name:
•
It works only for service activations through CoA. For services defined in dynamic-template and activated
by action in policy-maps, the service-activate event is not enabled, and a class map with match
service-name is not useful in that case.
•
It does not work in multi-action CoA (MA-CoA) where multiple services are enabled by a single CoA
request.
•
The order of configuration must be such that, the match service-name is configured in a class-map and
then the class-map is linked in the policy-map. The class-map must ideally be placed to match during a
service-start or service-stop event, where the service being started or stopped matches to the service
names configured in the class-map. With other events, the class-map with match service-name is irrelevant.
Task ID
OperationTask ID
read, writeqos
Examples
This is an example of configuring the class-map type control subscriber command in the class-map
configuration mode:
RP/0/RSP0/CPU0:router(config)# class-map type control subscriber CL1
RP/0/RSP0/CPU0:router(config-pmap)# match authen-status authenticated
RP/0/RSP0/CPU0:router(config-pmap-e)# match domain d1 format f1
RP/0/RSP0/CPU0:router(config-cmap-c)# match protocol ppp
RP/0/RSP0/CPU0:router(config-cmap-c)# match source-address ipv4 1.3.4.5 12.334.55.2
RP/0/RSP0/CPU0:router(config-cmap-c)# match timer time1
This is an example of configuring the service-name matching in the class-map (type subscriber) configuration
mode:
RP/0/RSP0/CPU0:router(config)# class-map type control subscriber match-any match-svc
RP/0/RSP0/CPU0:router(config-cmap)# match service-name idle-to
RP/0/RSP0/CPU0:router(config-cmap)# match service-name regexp id*
RP/0/RSP0/CPU0:router(config-cmap)# match service-name regexp .*
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
128
Control Policy Commands
match (class-map)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model