Cisco ASR 9000 Series - Pppoe Enable Bba-Group

pppoe enable bba-group
To enable pppoe on an interface, use the pppoe enable bba-group command in interface configuration mode.
To disable the pppoe on the interface, use the no form of this command.
pppoe enable bba-group bba-group name
no pppoe enable bba-group
Syntax Description
Specifies the name of the bba-group.
bba-group name
Command Default
If no BBA-Group is specified, then the default configuration options are used, else the BBA-Group's
configuration is used on this interface.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
When this configuration changes to use a different BBAGroup, then all existing PPPoE sessions running
under the interface are terminated.
Task ID
OperationTask ID
read, writeppp
Examples
This is an example of configuring the pppoe enable bba-group command in interface configuration mode:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router(config)#interface Bundle-Ether100.10
RP/0/RSP0/CPU0:router(config-if)# pppoe enable bba-group bba1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
453
PPPoE Commands
pppoe enable bba-group