template (BNG)
To configure the VPDN template and enter the vpdn template configuration mode, use the template command
in vpdn configuration mode. To disable vpdn template, use the no form of this command.
template vpdn-template_name{description| caller-id| ip| dsl-line-forwarding| ipv4| l2tp-class| tunnel| vpn}
no template
Syntax Description
Specifies the vpdn template name.
vpdn-template_name
Specifies the description of the vpdn template.description
Specifies the options to apply on calling station id.caller-id
Specifies the tos ip value.ip
Enables dsl line information forwarding.dsl-line-forwarding
Specifies the ipv4 settings for tunnel.ipv4
Specifies the l2tp class name.l2tp-class
Specifies the l2tp tunnel commands.tunnel
Specifies the vpn id/vrf name.vpn
Command Default
None
Command Modes
VPDN configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vpdn command, to enter vpdn configuration submode.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
420
PPPoE LAC-Specific Commands
template (BNG)
To Next Page
Loading...
Need help?
General
