Cisco ASR 9000 Series Command Reference

tunnel
To configure the amount of time that the peer will be put in a dead cache, use the tunnel command in vpdn
template configuration mode. To disable this feature, use the no form of this command.
tunnel busy list timeout timeout_value
no tunnel
Syntax Description
Specifies the amount of time in seconds that the peer will remain in dead cache.
This value ranges from 60 to 65535.
timeout_value
Command Default
None
Command Modes
VPDN template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vpdn template command to enter vpdn template configuration submode.
Task ID
OperationTask ID
read, writetunnel
Examples
This is an example of configuring the tunnel command in vpdn template configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# vpdn template
RP/0/RSP0/CPU0:router(config-vpdn-template)# tunnel busy list timeout 56
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
422
PPPoE LAC-Specific Commands
tunnel

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model