lpts punt excessive-flow-trap subscriber-interfaces
To enable the Excessive Punt Flow Trap feature on subscriber interfaces, use the lpts punt excessive-flow-trap
subscriber-interfaces command in Global Configuration mode. To disable the Excessive Punt Flow Trap
feature on subscriber interfaces, use the no form of this command.
lpts punt excessive-flow-trap subscriber-interfaces
no lpts punt excessive-flow-trap subscriber-interfaces
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
This example shows how to enable the Excessive Punt Flow Trap feature for subscriber interfaces in the
Global Configuration mode:
RP/0/RSP0/CPU0:router(config)# lpts punt excessive-flow-trap subscriber-interfaces
RP/0/RSP0/CPU0:router(config)#
Related Commands
DescriptionCommand
Displays the bad actor flows trapped by the Excessive Punt
Flow Trap feature.
show lpts punt excessive-flow-trap, on page 260
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
259
Excessive Punt Flow Trap Commands
lpts punt excessive-flow-trap subscriber-interfaces
To Next Page
Loading...
Need help?
General
