radius-server timeout (BNG)
To set the interval for which a router waits for a server host to reply before timing out, use the radius-server
timeout command. To restore the default, use the no form of this command.
radius-server timeout seconds
no radius-server timeout
Syntax Description
Number that specifies the timeout interval, in seconds. Range is from 1 to 1000.
seconds
Command Default
The default radius-server timeout value is 5 seconds.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported on BNG.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the radius-server timeout command to set the number of seconds a router waits for a server host to reply
before timing out.
Task ID
OperationsTask ID
read, writeaaa
Examples
This example shows how to change the interval timer to 10 seconds:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# radius-server timeout 10
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
49
BNG AAA Commands
radius-server timeout (BNG)
To Next Page
Loading...
