Cisco ASR 9000 Series Command Reference

qos account
To enable QoS Layer 2 overhead accounting, use the qos account command in dynamic template configuration
mode. To disable this qos account, use the no form of this command.
qos account[ AAL5|user-defined offset atm] [ mux-1483
routed|mux-dot1q-rbe|mux-pppoa|mux-rbe|snap-1483routed|snap-dot1q-rbe|snap-pppoa|snap-rbe ]
no qos account
Syntax Description
Specifies AAL5 for qos.AAL5
Specifies the user-defined keyword.user-defined
Specifies the user-defined offset size.
offset
Adds ATM cell tax to the L2 overhead.atm
Specifies the mux-1483 routed.mux-1483 routed
Specifies the mux-dot1q-rbe.mux-dot1q-rbe
Specifies the mux-pppoa.mux-pppoa
Specifies the mux-rbe.mux-rbe
Specifies the snap-1483routed.snap-1483routed
Specifies the snap-dot1q-rbe.snap-dot1q-rbe
Specifies the snap-pppoasnap-pppoa
Specifies the snap-rbe.snap-rbe
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
480
QOS Commands
qos account

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model