Cisco ASR 9000 Series - Aftr-Name

aftr-name
To set the Address Family Transition Router's (AFTR) name for Dual-stack Lite support, use the aftr-name
command in DHCPv6 server profile configuration mode. To disable the AFTR-name, use the no form of this
command.
aftr-name aftr-name
no aftr-name aftr-name
Syntax Description
Specifies the AFTR fully qualified domain name for the server profile.
aftr-name
Command Default
Dual-stack support is not enabled.
Command Modes
DHCPv6 server profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeip-services
Examples
This example shows how to configure the AFTR Fully Qualified Domain Name (FQDN) for a server profile:
RP/0/RSP0/CPU0:router(config)# dhcp ipv6
RP/0/RSP0/CPU0:router(config-dhcpv6)# profile my_profile server
RP/0/RSP0/CPU0:router(config-dhcpv6-server-profile)# aftr-name aftr-server.example.com
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
142
BNG DHCP Commands
aftr-name