Cisco ASR 9000 Series Command Reference

radius-server ipv4 dscp
To mark the dscp bit for the ipv4 packets, use the radius-server ipv4 dscp command in the Global
Configuration mode. To disable the Radius server IPv4 dscp, use the no form of this command.
radius-server ipv4 dscp value
no radius-server ipv4 dscp value
Syntax Description
Specifies the differentiated services codepoint value. The value ranges from 1 to
63.
value
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeaaa
Examples
This is an example of configuring the radius-server ipv4 dscp command in the Global Configuration mode:
RP/0/RSP0/CPU0:router(config)#radius-server ipv4 dscp 34
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
41
BNG AAA Commands
radius-server ipv4 dscp

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model