Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

l2tp reassembly

To configure the L2TP reassembly feature on L2TP Access Concentrator (LAC), use the l2tp reassembly

command in VPDN configuration mode. To disable this feature, use the no form of this command.

l2tp reassembly

no l2tp reassembly

Syntax Description

This command has no keywords or arguments.

Command Default

None

Command Modes

VPDN configuration

Command History

ModificationRelease

This command was introduced.Release 4.3.1

Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes appropriate task

IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator

for assistance.

Use the vpdn command inGlobal Configuration mode to enter the VPDN configuration mode.

When the L2TP reassembly is enabled, the line card supports 2000 concurrent flows in a steady state condition

and the traffic rate supported for each line card is 10,000 packets per second (pps), which is 10,000 packet

fragments IN per second and 5000 reassembled packets OUT per second.

Task ID

OperationTask ID

read, writetunnel

Examples

This example shows how to enable the L2TP reassembly feature on LAC:

RP/0/RSP0/CPU0:router# configure

RP/0/RSP0/CPU0:router(config)# vpdn

RP/0/RSP0/CPU0:router(config-vpdn)# l2tp reassembly

Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,

Release 5.2.x

414

PPPoE LAC-Specific Commands

l2tp reassembly

Cisco ASR 9000 Series Command Reference

Other manuals for Cisco ASR 9000 Series