Cisco ASR 9000 Series Command Reference

deactivate
To deactivate the dynamic template mode, use the deactivate command in the class map sub-configuration
mode. To disable this feature, use the no form of this command.
deactivate dynamic-template {name aaa list {list_name| default}}
no deactivate
Syntax Description
Specifies the actions related to dynamic templates.dynamic-template
Specifies the name of the dynamic template.
name
Specifies the AAA parameters.aaa
Specifies AAA method list that authentication should be made with.list
Specifies the default AAA method list.default
Specifies the name of the AAA method list.
list_name
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationTask ID
read, writeqos
Examples
This is an example of configuring the deactivate command in the class map sub-configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# policy-map type control subscriber PL1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
122
Control Policy Commands
deactivate

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model