pado delay remote-id
To set a delay for a PPPoE Active Discovery Offer (PADO) message for a particular PPPoE BBA-Group,
based on the Remote-ID received in PPPoE Active Discovery Initiator (PADI) message, use the pado delay
remote-id command in PPPoE BBA-Group configuration mode. To disable the PADO delay configuration
based on the Remote-ID, use the no form of this command.
pado delay remote-id {delay | {string | contains} string delay}
no pado delay remote-id {delay | {string | contains} string delay}
Syntax Description
Delay value for PADO message, in milliseconds,
based on the Remote-ID.
The range is from 0 to 10000.
delay
Delays the PADO message, when the Remote-ID
received in PADI message matches the configured
string.
string
Delays the PADO message, when the Remote-ID
received in PADI message contains the configured
string.
contains
String received in PADI message, that needs to be
matching the Remote-ID (when used along with
string keyword) or the string received in PADI
message, that needs to be contained within the
Remote-ID (when used along with the contains
keyword).
string
Command Default
None
Command Modes
PPPoE BBA-Group configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
446
PPPoE Commands
pado delay remote-id
To Next Page
Loading...
