Cisco ASR 9000 Series Command Reference

Setting a value of 0 for delay means that no transmission delay is set for the PADO message. Setting a value
of 10000 means that an infinite delay is set for PADO message; or, in other words, the PADO message is
never sent.
Within the category of Remote-ID matches, full string matches are preferred to sub-string matches. If more
than one sub-string match occurs, the selection is based on a random order.
If there is neither a string match nor a sub-string match, the configured Circuit-ID delay is used (if a Circuit-ID
is present in PADI message), followed by the configured Remote-ID delay (if a Remote-ID is present in PADI
message).
If there are no matches, the configured pado delay is used for PADO message.
Task ID
OperationTask ID
read, writeppp
Examples
This example shows how to configure a delay of 1000 milliseconds for the PADO message:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# pado delay remote-id 1000
This example shows how to configure a delay of 8000 milliseconds for the PADO message, if the Remote-ID
received in the PADI message exactly matches the configured string (remote1 in this example):
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# pado delay remote-id string remote1 8000
This example shows how to configure a delay of 5000 milliseconds for the PADO message, if the remote-id
received in the PADI message contains the configured string (remote2 in this example):
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# pado delay remote-id contains remote2 5000
Related Commands
DescriptionCommand
Configures a specific delay for PPPoE PADO message for a PPPoE
BBA-Group in BNG.
pado delay, on page 442
Configures a delay for PPPoE PADO message for a PPPoE BBA-Group
in BNG, based on the Circuit-ID received in PADI message.
pado delay circuit-id, on page 444
Configures a delay for PPPoE PADO message for a PPPoE BBA-Group
in BNG, based on the Service-Name received in PADI message.
pado delay service-name, on page
448
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
447
PPPoE Commands
pado delay remote-id

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model