Cisco ASR 9000 Series Command Reference

timeout idle
To configure an idle timeout period for the IPoE and PPPoE subscriber sessions on BNG, use the timeout
idle command in dynamic template type configuration mode. To disable this feature, use the no form of this
command.
timeout idle seconds [threshold rate] [traffic {both| inbound| outbound}]
no timeout idle seconds [threshold duration] [traffic {both| inbound| outbound}]
Syntax Description
Idle timeout value for the subscriber sessions, in
seconds.
The range is from 60 to 4320000.
seconds
Configures a threshold to track the duration of
session idleness.
threshold
Duration of threshold, in minute(s) per packet.
The range is from 1 to 10000. Default is 0.
This value should be less than the idle
timeout value.
Note
duration
Considers the direction of traffic while deriving
the duration of session idleness.
The default is inbound direction.
traffic
Considers inbound and outbound traffic while
deriving the duration of session idleness.
both
Considers inbound traffic only while deriving the
duration of session idleness.
inbound
Considers outbound traffic only while deriving the
duration of session idleness.
outbound
Command Default
None
Command Modes
Dynamic template type configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
246
Dynamic Template Commands
timeout idle

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model