aaa intercept
To enable RADIUS-based Lawful Intercept (LI) feature on a router, use the aaa intercept command in Global
Configuration mode. To disable RADIUS-based Lawful Intercept feature, use the no form of this command.
aaa intercept
no aaa intercept
Syntax Description
This command has no keywords or arguments.
Command Default
RADIUS-based Lawful Intercept feature is not enabled.
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
By default, Lawful Intercept (LI) is not a part of the Cisco IOS XR software.
The LI package needs to be installed separately. So, this command is enabled
only after installing and activating the asr9k-li-px.pie.
Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To use aaa intercept command, you must install and activate the asr9k-li-px.pie.
Use the aaa intercept command to enable a RADIUS-Based Lawful Intercept solution on your router. Intercept
requests are sent (through Access-Accept packets or CoA-Request packets) to the network access server
(NAS) or the Layer 2 Tunnel Protocol (L2TP) access concentrator (LAC) from the RADIUS server. All data
traffic going to, or from, a PPP or L2TP session is passed to a mediation device.
Task ID
OperationTask ID
read, writeaaa
readli
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
17
BNG AAA Commands
aaa intercept
To Next Page
Loading...
