Cisco ASR 9000 Series - Dynamic-Template Type Ipsubscriber

dynamic-template type ipsubscriber
To group a set of configuration items that can be applied to a group of subscribers based on the ipsubscriber
template type and to enter the dynamic-template configuration mode, use the dynamic-template type
ipsubscriber command. To disable this feature and exit the dynamic-template configuration mode, use the
no form of this command.
dynamic-template type ipsubscriber template-name
no dynamic-template type ipsubscriber template-name
Syntax Description
Specifies the dynamic template name.
template-name
Command Default
None
Command Modes
Dynamic template configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
Use the dynamic-template command to enter dynamic template configuration mode.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This is an example of configuring the dynamic-template type ipsubscriber command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ipsubscriber ipsub1
Related Commands
DescriptionCommand
Enables the dynamic template configuration mode.dynamic-template, on page 232
Enables the ppp dynamic template type.dynamic-template type ppp, on page 236
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
234
Dynamic Template Commands
dynamic-template type ipsubscriber