Cisco ASR 9000 Series Command Reference

service-policy (QoS-BNG)
To enable the QoS policy on a parent S-VLAN, or to enable ingress and egress VLAN policies on an
access-interface, use the service-policy command in the interface configuration mode. To disable this feature,
use the no form of this command.
Egress S-VLAN Policy:
service-policy output service_policy_name subscriber-parent [resource-id value ]
no service-policy output service_policy_name subscriber-parent [resource-id value ]
Ingress and Egress VLAN Policies:
service-policy {input | output} service_policy_name
no service-policy {input | output} service_policy_name
Syntax Description
Attaches the specified service-policy to the ingress
direction.
input
Attaches the specified service-policy to the egress
direction.
output
Name of the input or output service-policy.
service_policy_name
Configures an S-VLAN policy.
This keyword applies only to the egress
direction.
Note
subscriber-parent
Specifies a resource ID that allows to map the desired
chunk to be used for this S-VLAN and all the
subscribers under it.
This keyword applies only to an S-VLAN
policy and not to VLAN policy.
Note
resource-id
The resource ID value that ranges from 0-3.
value
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
484
QOS Commands
service-policy (QoS-BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model